HP LaserJet P4015 Printer series - Manual (Page 31)

Configure Device menu
Use this menu to change the default printing settings, adjust the print quality, and change the system
configuration and I/O options.
Printing submenu
Some items on this menu are available in the program or printer driver. Program and printer-driver
settings override control-panel settings. In general, it is better to change these settings in the printer
driver, if applicable.
Item Values Explanation
COPIES 1 to 32000 Set the default number of copies by selecting any number from 1
to 32000. Use the numeric keypad to enter the number of copies.
For products that do not have a numeric keypad, press the up
arrow or the down arrow to select the number of copies. This
setting applies only to print jobs that do not have the number of
copies specified in the program or printer driver, such as a UNIX
or Linux program.
The default setting is 1.
NOTE: It is best to set the number of copies in the program or
printer driver. (Program and printer-driver settings override
control-panel settings.)
DEFAULT PAPER SIZE Displays a list of available
paper sizes. Set the default image size for paper and envelopes. This setting
applies to the print jobs that do not have a paper size specified in
the program or printer driver. The default setting is LETTER.
DEFAULT CUSTOM PAPER
SIZE UNIT OF MEASURE
XDIMENSION
YDIMENSION
Set the default custom paper size for Tray 1 or any 500-sheet
tray.
UNIT OF MEASURE: Use this option to select the unit of measure
(INCHES or MILLIMETERS) to use when you set custom paper
sizes.
XDIMENSION: Use this item to set the measurement of the width
of the paper (measurement from side to side in the tray). The
range is 76 to 216 mm (3.0 to 8.50 inches).
YDIMENSION: Use this item to set the measurement of the length
of the paper (measurement from front to back in the tray). The
range is 127 to 356 mm (5.0 to 14.0 inches).
PAPER DESTINATION Displays a list of possible
paper destinations. Configure the output paper bin destination. The list varies
according to which output accessory is attached. The default is
STANDARD TOP BIN.
DUPLEX OFF
ON
This item appears only when an optional duplexer is installed. Set
the value to ON to print on both sides (duplex) or OFF to print on
one side (simplex) of a sheet of paper.
The default setting is OFF.
DUPLEX BINDING LONG EDGE
SHORT EDGE
Change the binding edge for duplex printing. This item appears
only when an optional duplexer is installed and DUPLEX is set to
ON.
The default setting is LONG EDGE.
OVERRIDE A4/LETTER NO Select YES to print an A4-size job on Letter-size paper if A4-size
paper is not loaded in the product (or vice versa).
ENWW Configure Device menu 19