HP LaserJet P4015 Printer series User Manual
Page 170
Control panel message
Description
Recommended action
TOO MANY TRAYS INSTALLED
You have installed more optional trays than
the product supports.
The product can accept up to four optional
500-sheet trays, or it can accept one optional
1,500-sheet tray and up to three optional 500-
sheet trays, for a total of up to four optional
trays.
Remove one of the optional trays.
TRAY <XX> [TYPE] [SIZE]
To change size or type press OK
alternates with
TRAY <XX> [TYPE] [SIZE]
To accept settings press
This message states the current type and
size configuration of the paper tray, and
allows you to change the configuration.
To change the paper size or type press
OK
while the message is present. To clear the
message, press the back arrow
while the
message is present.
●
Set size and type to ANY if the tray is
used frequently for different sizes or
types.
●
Set size and type to a specific setting if
printing with only one type of paper.
TRAY <XX> OPEN
For help press
alternates with
<Current status message>
The tray cannot feed paper to the product
because tray [X] is open and must be closed
for printing to continue.
Check the trays and close any that are open.
Unable to mopy job
alternates with
Current status message
Memory or file system failures would not
allow a mopy job to occur. Only one copy will
be produced.
Correct the error and then try again to store
the job.
Unable to store job
alternates with
<Current status message>
The print job named cannot be stored due to
a memory, disk, or configuration problem.
Correct the error and then try again to store
the job.
UNSUPPORTED HOST USB DEVICE
DETECTED
An unsupported USB device has been
inserted into a USB port.
The product cannot use the USB device.
Remove the device.
USB HUBS NOT FULLY SUPPORTED
For help press
The product does not meet the power
requirement of the USB hub.
Some operations may not work properly.
USB STORAGE DEVICE FAILURE
To clear press OK
The specified device has failed.
Press
OK
to continue.
USB STORAGE FILE OPERATION FAILED
To clear press OK
A command attempted an illogical operation. Press
OK
to continue.
USB STORAGE FILE SYSTEM IS FULL
To clear press OK
The specified file system is full and cannot be
written to.
Press
OK
to continue.
USB STORAGE IS WRITE PROTECTED
To clear press OK
The device cannot be written to.
Press
OK
to continue.
Table 10-1
Control-panel messages (continued)
158 Chapter 10 Solve problems
ENWW