HP LaserJet P4015 Printer series - Manual (Page 34)

Print Quality submenu
Some items on this menu are available in the program or printer driver. Program and printer-driver
settings override control-panel settings. In general, it is best to change these settings in the printer driver,
if applicable.
Item Values Explanation
SET REGISTRATION PRINT TEST PAGE
SOURCE
ADJUST TRAY [N]
Shifts the margin alignment to center the image on the page
from top to bottom, and left to right. You can also align the
image that is printed on the front with the image that is printed
on the back. Allows for one-sided and two-sided printing
alignment.
PRINT TEST PAGE: Prints a test page that shows the current
registration settings.
SOURCE: Selects the tray for which you want to print the test
page.
ADJUST TRAY [N]: Sets the registration for the specified tray,
where [N] is the number of the tray. A selection appears for
each tray that is installed, and registration must be set for each
tray.
● X1 SHIFT: Registration of the image on the paper from
side to side, as the paper lies in the tray. For duplexing,
this side is the second side (back) of the paper.
● X2 SHIFT: Registration of the image on the paper from
side to side, as the paper lies in the tray, for the first side
(front) of a duplexed page. This item appears only if the
product includes a built-in duplexer and DUPLEX is ON.
Set the X1 SHIFT first.
● Y SHIFT: Registration of the image on the paper from top
to bottom as the paper lies in the tray.
The default setting for SOURCE is TRAY 2. The default setting
for ADJUST TRAY 1 and ADJUST TRAY 2 is 0.
FUSER MODES List of available paper types Configures the fuser mode associated with each paper
type.
Change the fuser mode only if you are experiencing problems
printing on certain paper types. After you select a type of paper,
you can select a fuser mode that is available for that type. The
product supports the following modes:
NORMAL: Used for most types of paper.
LIGHT1: Used for most types of paper.
LIGHT2: Use this mode if you are experiencing wrinkled
media.
HEAVY: Used for rough paper.
The default fuser mode is LIGHT1 for all print media types
except transparencies (LIGHT2) and rough paper (HEAVY).
22 Chapter 2 Control panel ENWW