HP LaserJet P4015 Printer series - Manual (Page 76)

Service name Description
BOOTP (Bootstrap Protocol) For automatic IP address assignment. The BOOTP server
provides the product with an IP address. Requires the
administrator to input a product's MAC hardware address on
the BOOTP server for the product to obtain an IP address from
that server.
Auto IP For automatic IP address assignment. If neither a DHCP
server nor a BOOTP server is present, the product uses this
service to generate a unique IP address.
Configure the network product
View or change network settings
You can use the embedded Web server to view or change IP configuration settings.
1. Print a configuration page. On the embedded Jetdirect page, locate the IP address.
● If you are using IPv4, the IP address contains only digits. It has this format:
xx.xx.xx.xx
● If you are using IPv6, the IP address is a hexadecimal combination of characters and digits.
It has this format:
xxxx::xxx:xxxx:xxxx:xxxx
2. Type the IP address into the address line of a Web browser to open the embedded Web server.
3. Click the Networking tab to obtain network information. You can change settings as needed.
Set or change the network password
Use the embedded Web server to set a network password or change an existing password.
1. Open the embedded Web server and click the Settings tab.
2. In the left-side pane, click Security.
NOTE: If a password has previously been set, you are prompted to type the password. Type the
password, and then click Apply.
3. In the area for Device Password, type the new password in the New Password box and in the
Verify Password box.
4. At the bottom of the window, click Apply to save the password.
Table 5-4 IP addressing (continued)
64 Chapter 5 Connectivity ENWW