HP StorageWorks XP Remote Web Console Software - Manual (Page 173)

Chapter 5 Configuring Storage Systems and Logical Paths 5-3
Hitachi Universal Replicator for IBM /OS User’s Guide
Note: Throughout this chapter, the primary and the secondary storage
systems are sometimes referred to as local storage systems or remote storage
systems. If you are logged into the primary storage system and are using URz,
the primary storage system is a local storage system and the secondary
storage system is a remote storage system. If you are logged into the
secondary storage system and are using URz, the secondary storage system is
a local storage system and the primary storage system is a remote storage
system.
Note: When performing system configuration, the administrator also needs to
configure journal groups. For detailed information about configuring journal
groups, see Chapter 6.
Setup Procedure for Multiple Primary and Secondary Storage
Systems
After you have installed the URz hardware and software, you can configure the
primary storage systems and secondary storage systems for URz operations.
To configure the primary storage systems and secondary storage systems for
URz operations:
1. Identify the volumes that will become the URz data volumes and journal
volumes in primary storage system and secondary storage system. You
need to know the storage system S/N and the controller ID, so that you
can configure the primary storage systems and secondary storage systems
correctly for your desired pairs. When you create the pairs, you will need to
know the LDKC number, the CU number, and the LDEV number of each
volume.
2. Connect to the USP V storage system that you want to use. For further
information on USP V Storage Navigator installation and operations, please
refer to the Storage Navigator User's Guide, or contact your Hitachi Data
Systems account team. Operate at a primary storage system and a
secondary storage system.
Note: You must log in with Administrator or URz write access, and you must
be in modify mode. If you are in the view mode, you can refer to the URz
pair status, but you cannot modify the settings.
3. When you click Go, Universal Replicator for z/OS and then URz
Monitor on the menu bar of the Storage Navigator main window, URz
starts and the URz window is active. Operate at a primary storage system
and a secondary storage system.
4. Select the Port radio button on the DKC Operation window, set the initiator
and RCU target ports. Operate at a primary storage system and a
secondary storage system.