Deleting journal volumes from a journal group – HP StorageWorks XP Remote Web Console Software User Manual
Page 207
Chapter 6 Configuring Journal Groups
6-9
Hitachi Universal Replicator for IBM /OS User’s Guide
Deleting Journal Volumes from a Journal Group
To delete journal volumes from the primary storage system, log into the
primary storage system and then perform the following operation.
To delete journal volumes from the secondary storage system, log into the
secondary storage system and then perform the following operation.
1. Ensure that the Storage Navigator main window is in Modify mode.
For detailed information about how to do this, please refer to Storage
Navigator User’s Guide.
2. Ensure that the Journal Operation window is displayed.
3. In the tree of the Journal Operation window, select a journal group from
below Registered.
Note: You cannot select more than one journal group.
4. Do either of the following:
–
In the tree, right-click the selected journal group and then select JNL
Volumes from the pop-up menu.
–
In the upper-right list, select and right-click the desired journal group
and then select JNL Volumes from the pop-up menu.
Caution: As a general rule, you can delete journal volumes only when the
attribute of the journal group is Initial or when the status of the journal
group is Stop. or Hold(Failure). However, when one journal group uses
multiple mirror IDs, you can delete journal volumes only in the case shown
in the following table.
Table 6-1
Requirement to Delete Journal Volumes (When One Journal
Group Uses Two Mirror IDs)
Status of Journal Group
Mirror ID 1
Mirror ID 2
Can the Journal Volumes be Deleted?
Active Hold
No.
Active Hold(Failure) No.
Stop Hold
Yes.
Stop Hold(Failure) Yes.
5. In the JNL Volumes list of the Edit JNL Volumes window (Figure 6-1),
select the volumes that you want to delete.
In the JNL Volumes list, one row represents one volume.
6. Select Delete.
The volumes that you want to delete will be displayed in blue italics. The
Operation column of the list displays Delete.
7. Select Set to close the Edit JNL Volumes window.