HP StorageWorks XP Remote Web Console Software - Manual (Page 227)

Chapter 7 Using Extended Consistency Groups 7-3
Hitachi Universal Replicator for IBM /OS User’s Guide
1. Ensure that the Storage Navigator main window is in Modify mode.
For detailed information about how to do this, please refer to Storage
Navigator User’s Guide.
2. Ensure that the EXCTG Operation window is displayed.
3. In the EXCTG Operation window (Figure 4-11), select and right-click an
extended consistency group in the tree or in the list.
4. Select Add JNLG to EXCTG from the pop-up menu.
The Add JNL Group window appears (Figure 7-1).
5. If you do not want to register journal groups of the supervisor DKC, clear
the check box of far left of the DKCs (DKC-1 to DKC-4). If you want to
register journal groups of the supervisor DKC, select the check box of far
left of the DKCs (DKC-1 to DKC-4).
6. Select one from the DKCs (DKC-1 to DKC-4).
Notes:
– The word "DKC" represents a storage system.
– If you want to register journal groups of the supervisor DKC, please
move on to step 11 after this step.
7. Enter the serial number of the storage system.
Note: If the serial number is already displayed and unchangeable, you do
not need to enter it.
8. Enter the LDKC number.
Note: If the LDKC number is already displayed and unchangeable, you do
not need to enter it.
9. Select the control ID.
10. Specify the LDKC number and the LDEV number of the remote command
device.
Note: If the LDKC number and the LDEV number are already specified and
unchangeable, you do not need to specify them.
11. From the JNLG list on the left, select one or more journal groups that you
want to register.
12. Select ->Add.
The selected journal groups move to the JNLG list on the right.
Note: If the JNLG list on the right contains any journal group that you do
not want to register, please select the journal group from the list and then
click <-Cancel.
13. From Mirror ID, select a mirror ID.
Note: If a mirror ID is already specified and unchangeable, you do not
need to select it.
14. If necessary, repeat steps 6 to 13.
15. Select Set to close the Add JNL Group window.