HP StorageWorks XP Remote Web Console Software - Manual (Page 258)

8-24 Chapter 8 Performing Pair Operations
Hitachi Universal Replicator for IBM /OS User’s Guide
– If you want to modify a setting, select and right-click the setting and
then select Modify.
– If you want to cancel a setting, select and right-click the setting and
then select Cancel.
10. Select Apply to restore pair(s).
Note: If an error occurs, the rightmost column of the Preview list displays
the error code. To view detailed information about the error, right-click the
error code and then select Error Detail. An error message appears and
gives you detailed information about the error.
11. In the list of the Pair Operations window, verify that the pair(s) has been
restored successfully.
If the pair has been restored successfully, the status of the pair is Pending
or Duplex.
– If the pair has been restored successfully, the status of the pair is
Pending or Duplex.
– If delta resync operation has been performed successfully, the status of
the pair is Pending or Duplex.
– If the operation to change pair status has been performed successfully,
the status of the pair changes to Hold.
12. To monitor the progress of restoring pair(s), click File, Refresh on the
menu bar of the Storage Navigator main window to update the information
in the list, or use the Detailed Information window to monitor the detailed
status of each pair.
Figure 8-7 Resume Pair Window
The Resume Pair window displays the following:
• Range: Allows you to specify the restore range. The default is Volume if
two or more pairs in the same mirror are selected. The default is Group if
not. Note that the default setting is Group when the pair status is Hold or
Hlde, and in that case you cannot change the default setting.
– Volume: Only the specified pair(s) will be restored.