HP StorageWorks XP Remote Web Console Software - Manual (Page 236)

8-2 Chapter 8 Performing Pair Operations
Hitachi Universal Replicator for IBM /OS User’s Guide
To perform remote copy operations with URz, you must create pairs of a
primary data volume and a secondary data volume. A primary data volume is
a data volume to be copied. A secondary data volume is a data volume that is
the copy destination for a primary data volume. To manipulate pairs of these
data volumes, use the Pair Operation window of URz.
Note: This manual sometimes uses the term "volume pair" when referring to a
pair of a primary data volume and a secondary data volume.
Filtering Information in the List in the Pair Operation
Window
The Display Filter window (Figure 8-1) enables you to filter information in the
list in the Pair Operation window. The list will display only the volumes that
satisfy certain conditions.
To filter information in the list in the Pair Operation window:
1. In the Pair Operation window (Figure 4-2), select Display Filter.
2. Use the Display Filter window to specify information that you want to
display in the list.
3. Select Set to close the Display Filter window.
The list in the Pair Operation window displays the specified information only.
Notes:
• To restore the list to the default status (i.e., the status before filtering),
select Reset in the Display Filter window and then Set in the same window.
• If you change settings in the Display Filter window, the changes will remain
effective during the URz session until you reset the settings.