HP Designjet Z3100 Photo Printer series User Manual
Page 144
Advertising
11.
Fit the cutter stop onto the end of the cutter rail, holding it there with one hand while you tighten the
screw with the screwdriver in your other hand.
12.
Put the left end cover back on the printer, aligning the protrusions with the holes in the printer.
13.
Close the ink cartridge cover.
14.
At the front panel, turn the printer back on. The printer checks that the cutter has been correctly
installed. Look at the front panel and follow its instructions if there is any problem.
134 Chapter 10 Maintaining the printer
ENWW
Maintaining the printer
Advertising