HP ProCurve 520wl Wireless Access Point - Manual (Page 114)

Commands
Reset
Use the Reset tab to restore the AP to factory default conditions. The AP may also be reset from the RESET button
located on the side of the unit. Since this will reset the Access Point’s current IP address, a new IP address must be
assigned. Refer to
Recovery Procedures for more information.
! CAUTION
Resetting the AP to its factory default configuration will permanently overwrite all changes that have made to
the unit. The AP will reboot automatically after this command has been issued.
Figure 6-14 Reset to Factory Defaults Command Screen
6-11