HP ProCurve 520wl Wireless Access Point - Manual (Page 154)

Command Line Interface (CLI)
Maintain Client Connections using Link Integrity
[Device-Name]>show linkinttbl (this shows the current links)
[Device-Name]>set linkinttbl <1-5 (depending on what table row you wish to address)>
ipaddr <ip address of the host computer you want to check>
[Device-Name]>set linkintpollint <the interval between link integrity checks>
[Device-Name]>set linkintpollretx <number of times to retransmit before considering
the link down>
[Device-Name]>set linkintstatus enable
[Device-Name]>show linkinttbl (confirm new settings)
[Device-Name]>reboot 0
Change your Wireless Interface Settings
See Interfaces for information on the parameters listed below. Dual-radio APs use index 3 for Slot A and index 4 for
Slot B.
Operational Mode
[Device-Name]>set wif <index> mode <see table>
mode Operational Mode
1 dot11b-only
2 dot11g-only
3 dot11bg
4 dot11a-only
5 dot11g-wifi
Autochannel Select (ACS)
ACS is enabled by default. Reboot after disabling or enabling ACS.
[Device-Name]>set wif <index> autochannel <enable/disable>
[Device-Name]>reboot 0
Enable/Disable Closed System
[Device-Name]>set wif <index> closedsys <enable/disable>
Enable/Disable Interference Robustness (802.11b Only)
[Device-Name]>set wif <index> interrobust <enable/disable>
Enable/Disable Load Balancing (802.11b Only)
[Device-Name]>set wif <index> ldbalance <enable/disable>
Enable/Disable Medium Density Distribution (802.11b Only)
[Device-Name]>set wif <index> meddendistrib <enable/disable>
C-18