HP ProCurve 520wl Wireless Access Point - Manual (Page 156)

Command Line Interface (CLI)
Set Communication Ports
[Device-Name]>set httpport <HTTP port number
(default is 80)>
[Device-Name]>set telport <Telnet port number
(default is 23)>
Configure Secure Socket Layer (HTTPS)
Enabling SSL and configuring a passphrase allows encrypted Secure Socket Layer communications to the AP through
the HTTPS interface.
[Device-Name]>set sslstatus <enable/disable>
The user must change the SSL passphrase when uploading a new certificate/private key pair, which will have a
corresponding passphrase.
[Device-Name]>set sslpassphrase <SSL certificate passphrase>
[Device-Name]>show http
To view all HTTP configuration information including SSL.
HTTP Group Parameters
=====================
httpifbitmask : 15
httppasswd : ********
httpport : 80
httphelplink : c:/Program Files/HP/AP_520wl/Help/English/Index.htm
httpsetupwiz : disable
sslstatus : enable
sslpassphrase : ********
Set Telnet Session Timeouts
[Device-Name]>set tellogintout <time in seconds between 1 and 300 (default is 30)>
[Device-Name]>set telsessiontout <time in seconds between 1 and 36000 (default is 900)>
Configure Serial Port Interface
NOTE
To avoid unexpected performance issues, leave Flow Control at the default setting (none) unless you are sure
what this setting should be.
[Device-Name]>set serbaudrate <2400, 4800, 9600, 19200, 38400, 57600>
[Device-Name]>set serflowctrl <none, xonxoff>
[Device-Name]>show serial
Figure C-16 Result of “show serial” CLI Command
Configure Syslog
[Device-Name]>set syslogpriority <1-7 (default is 6)>
[Device-Name]>set syslogstatus <enable/disable>
C-20