HP ProCurve 520wl Wireless Access Point - Manual (Page 153)

Command Line Interface (CLI)
Other Network Settings
There are other configuration settings that you may want to set for the AP. Some of them are listed below.
– Configure the AP as a DHCP Server
– Configure the DNS Client
– Maintain Client Connections using Link Integrity
– Change your Wireless Interface Settings
– Set Ethernet Speed and Transmission Mode
– Set Interface Management Services
– Configure MAC Access Control
– Set RADIUS Parameters
– Set Rogue Access Point Detection (RAD) Parameters
– Set VLAN/SSID Parameters
NOTE
Refer to Advanced Configuration for more information on these settings.
Configure the AP as a DHCP Server
NOTE
You must have at least one entry in the DHCP Server IP Address Pool Table before you can set the DHCP
Server Status to Enable.
[Device-Name]>set dhcpstatus disable
[Device-Name]>set dhcpippooltbl 0 startipaddr <start ip address>
endipaddr <end ip address>
[Device-Name]>set dhcpgw <gateway ip address>
[Device-Name]>set dhcppridnsipaddr <primary dns ip address>
[Device-Name]>set dhcpsecdnsipaddr <secondary dns ip address>
[Device-Name]>set dhcpstatus enable
[Device-Name]>reboot 0
! CAUTION
Before enabling this feature, confirm that the IP address pools you have configured are valid addresses on the
network and do not overlap the addresses assigned by any other DHCP server on the network. Enabling this
feature with incorrect address pools will cause problems on your network.
Configure the DNS Client
[Device-Name]>set dnsstatus enable
[Device-Name]>set dnsprisvripaddr <IP address of primary DNS server>
[Device-Name]>set dnssecsvripaddr <IP address of secondary DNS server>
[Device-Name]>set dnsdomainname <default domain name>
[Device-Name]>show dns
Figure C-15 Results of “show dns” CLI command
C-17