HP ProCurve 520wl Wireless Access Point - Manual (Page 139)

Command Line Interface (CLI)
Bootloader CLI
The Bootloader CLI is a minimal subset of the normal CLI used to perform initial configuration of the AP. This interface
is only accessible by way of the serial interface if the AP does not contain a software image or a download image
command over TFTP has failed.
The Bootloader CLI provides you with the ability to configure the initial setup parameters as well as download a
software image to the device.
The following functions are supported by the Bootloader CLI:
– configuration of initial device parameters using the set command
– show command to view the device’s configuration parameters
– help command to provide additional information on all commands supported by the Bootloader CLI
– reboot command to reboot the device
The parameters supported by the Bootloader CLI (for viewing and modifying) are:
– System Name
– IP Address Assignment Type
– IP Address
– IP Mask
– Gateway IP Address
– TFTP Server IP Address
– Image File Name (including the file extension)
The following lists display the results of using the help command in the Bootloader CLI:
Figure C-1 Results of “help” bootloader CLI command
The following lists display the results of using the show command in the Bootloader CLI:
Figure C-2 Results of “show” bootloader CLI command
C-3