HP ProCurve 520wl Wireless Access Point - Manual (Page 158)

Command Line Interface (CLI)
Set RADIUS Parameters
Configure RADIUS Authentication server
[Device-Name]>set radiustbl <index> status enable seraddrfmt <ipaddr or name>
ipaddr <RADIUS IP address or name> port <user defined>
ssecret <user defined> responsetm <1 to 10 seconds>
maxretx <0 to 4 times>
[Device-Name]>show radiustbl
Figure C-17 Results of “show radiustbl” CLI command
Enable RADIUS MAC Access Control
[Device-Name]>set radmacaccctrl enable
[Device-Name]>reboot 0
Set MAC Address Format Type
[Device-Name]>set radmacaddrformat <dashdelimited, colondelimited, singledashdelimited,
nodelimiter>
Set Authorization Lifetime (MAC-based authentication only)
[Device-Name]>set radauthlifetm <900-43200 seconds; default is 900>
Enable RADIUS Accounting
[Device-Name]>set radaccstatus enable
[Device-Name]>set radaccinactivetmr <inactivity timer in minutes>
[Device-Name]>show radius
C-22