HP ProCurve 520wl Wireless Access Point - Manual (Page 49)

Advanced Configuration
Figure 4-4 Link Integrity Configuration Screen
Interfaces
From the Interfaces tab, you configure the Access Point’s operational mode, power control settings, wireless interface
settings and Ethernet settings. You may also configure a Wireless Distribution System for AP-to-AP communications.
For the wireless interface configuration, refer to the wireless parameters below that correspond to your radio type.
– Operational Mode
– Wireless (802.11a)
– Wireless (802.11b)
– Wireless (802.11b/g)
– Wireless Distribution System (WDS)
– Ethernet
4-7