HP ProCurve 520wl Wireless Access Point - Manual (Page 174)

Command Line Interface (CLI)
Port Number Octet String User Defined
(there are also 4
pre-defined protocols:
Index 1: NetBios Name
Service – 137, Index 2:
NetBios Datagram
Service – 138, Index 3:
NetBios Session
Service – 139, Index 4:
SNMP Service – 161) RW portnum
Protocol Name DisplayString User Defined
(there are also 4
pre-defined protocols,
see
Port Number above)
RW protoname
Interface Bitmask Integer32 0 or 2 - no interfaces
(disable)
1 or 3 - Ethernet
4 or 6 - Wireless A
8 or 10 - Wireless B
12 = Wireless A & B
13 or 15 - all interfaces
(default is 15) RW ifbitmask
Status (optional) Integer enable (default for new
entries)
disable (default for
pre-defined entries)
delete RW status
Alarms Parameters
SNMP Table Host Table Parameters
When creating table entries, you may either specifying the argument name followed by argument value. CLI applies
default values to the omitted arguments. Due to the nature of the information, the only argument that can be omitted is
the “comment” argument.
Name Type Values Access CLI Parameter
SNMP Trap Host Table Table N/A R snmptraphosttbl
Table Index Integer User Defined N/A index
IP Address IpAddress User Defined RW ipaddr
Password DisplayString User Defined (up to 64
characters) W passwd
Comment (optional) DisplayString User Defined (up to 254
characters) RW cmt
Status (optional) Integer enable (default)
disable
delete RW status
Syslog Parameters
The following parameters configure the Syslog settings.
Name Type Values Access CLI
Syslog Group N/A R syslog
Syslog Status Integer enable
disable (default) RW syslogstatus
Syslog Port Octet String 514 R syslogport
C-38