HP XP RAID Manager Software - Manual (Page 66)

Description Status
• The status of the resource is being confirmed.
•
The resource has sub-resources of different status.
For example, parity groups are in this status if the statuses of logical volumes in the parity
groups are not the same.
In this case, the sub-resources might be blocked. Confirm the status of sub-resources.
The resource is in the following status.
•
The resource cannot be used because the resource is blocked due to a failure or maintenance
operations.
• The status of the resource is unknown.
Restore the resource to the normal status.
Viewing Remote Web Console data using an external application
You can load and view data that is displayed in Remote Web Console in an external application,
such as HP Systems Insight Manager.
Prerequisites
•
The SVP must be configured to load Remote Web Console data to another application. Contact
your service representative.
•
To add an application, information about the application must be specified in the application
information file. Contact your service representative to ask about how to obtain the application
information file.
Procedure 41 To launch another application to view Remote Web Console data:
1. Open a Remote Web Console window and select rows that you want to view in another
application.
2. Click Settings
→Launch Application→Application Name. The application starts with the selected
data.
Using reports to verify system changes
This section explains Remote Web Console reports and provides instructions for creating, viewing,
and deleting reports.
You can create reports in Remote Web Console of your storage system’s physical configurations
and logical settings. Doing this provides a copy of the settings when you intend to make changes.
If you make a similar report after the changes, then you can compare the reports to verify that new
settings were made as intended.
Remote Web Console reports can be saved in a CSV or HTML file. Tables in the HTML version of
the configuration report are sortable.
See “Storage configuration reports” (page 90) for descriptions of the individual reports.
Creating a configuration report
You can create up to 20 configuration reports, then view or download them.
Procedure 42 To create a configuration report:
1. From General Tasks, click Create Configuration Report.
2. Specify a task name and click Apply. This task name will be used as the report name in the
Reports window. This process takes approximately 10 minutes to complete.
3. Click Refresh View to update the Reports window. The created report appears in the list.
66 Viewing and managing the storage system