HP XP P9500 Storage - Manual (Page 78)

Table 17 CDELPAIR parameters
Description Value Parameter
NA Device number DEVN
These parameters must be used for successful
execution of the command. Primary volume: SSID, serial number, channel
connection address, and CU number. PRIM
To delete all pairs in a consistency group,
MAnn0 must be set. nn is the CTG ID.
NA Secondary volume: SSID, serial number,
channel connection address, and CU number. SEC
CDELPAIR example
DELPAIR
The following table describes the PPRCOPY DELPAIR command parameters used to delete pairs.
Table 18 PPRCOPY DELPAIR parameters
Description Value Parameters
Only one of the three parameters should be
specified. The italic term is the arbitrary name. DDNAME = dname = JCL statement identifying
the volume. DDNAME,
SYSNAME, or
UNITADDRESS
For example, dname is the arbitrary unique
SYSNAME = sysxxx = SYSNAME in the ASSGN
system control statement.
name of the JCL statement which identifies the
volume.
UNITADDRESS = ccuu = device number.
These parameters must be used for successful
execution of the command. Primary volume: SSID, serial number, channel
connection address. PRI
To delete all pairs in a consistency group, MAnn0
must be set. nn is the CTG ID.
NA Secondary volume: SSID, serial number, channel
connection address. SEC
NA P-VOL or S-VOL CU number. LSS
DELPAIR example
Consistency group pair operations with PPRC
With PPRC, you can split, resynchronize, and delete the pairs in a consistency group at the same
time. This section provides instructions for creating consistency groups and perform the pair
operations.
78 Pair operations using PPRC