HP LaserJet M1522 Multifunction Printer series - Manual (Page 120)

5. Use the arrow buttons to select On or Off, and then press OK .
6. If you turn on the fax-forwarding feature, use the alphanumeric buttons to specify the fax number
where the fax is to be sent, and then press
OK to save the selection.
Set up distinctive ring
Ring-pattern or distinctive-ring service is available through some local telephone companies. The
service allows you to have more than one telephone number on a single line. Each telephone number
has a unique ring pattern, so that you can answer voice calls and the product can answer fax calls.
If you subscribe to a ring-pattern service with a telephone company, you must set the product to answer
the correct ring pattern. Not all countries/regions support unique ring patterns. Contact the telephone
company to determine if this service is available in your country/region.
NOTE: If you do not have ring-pattern service and you change the ring-pattern settings to something
other than the default, All Rings, the product might not be able to receive faxes.
The settings are as follows:
● All Rings: The product answers any calls that come through the telephone line.
● Single: The product answers any calls that produce a single-ring pattern.
● Double: The product answers any calls that produce a double-ring pattern.
● Triple: The product answers any calls that produce a triple-ring pattern.
● Double&Triple: The product answers any calls that produce a double-ring or triple-ring pattern.
To change ring patterns for call answering, complete the following steps:
1. On the control panel, press Setup ( ).
2. Use the arrow buttons to select Fax setup, and then press OK.
3. Use the arrow buttons to select Fax Recv. setup, and then press OK .
4. Use the arrow buttons to select Answer Ring Type, and then press OK .
5. Use the arrow buttons to select the ring pattern that you want, and then press OK .
6. After product installation is complete, ask someone to send a fax to you in order to verify that the
ring-pattern service is working correctly.
Set up the computer to receive faxes
NOTE: Receiving faxes by using a computer is not supported for Macintosh.
Receiving faxes to a computer is available only if a full software installation was performed during initial
product setup.
To receive faxes to your computer, turn on the receive-to-PC setting in the software.
1. Open HP ToolboxFX.
2. Select the product.
3. Click Fax.
108 Chapter 10 Fax ENWW