Delete faxes from memory, Use fax on a dsl, pbx, isdn, or voip system, Ts, see – HP LaserJet M1522 Multifunction Printer series User Manual
Page 125: Use fax on a dsl
Use the following steps to cancel a fax job by using the Fax Job status menu:
1.
On the control panel, press
Setup
( ).
2.
Press
OK
to select Fax Job status.
3.
Use the arrow buttons to scroll through pending jobs until you reach the job that you want to clear.
4.
Press
OK
to select the job that you want to cancel.
5.
Press
OK
to confirm that you want to cancel the job.
Delete faxes from memory
Use this procedure only if you are concerned that someone else has access to your product and might
try to reprint faxes from the memory.
CAUTION:
In addition to clearing the reprint memory, this procedure clears any fax that is currently
being sent, unsent faxes that are pending redial, faxes that are scheduled to be sent at a future time,
and faxes that are not printed or forwarded.
1.
On the control panel, press
Setup
( ).
2.
Use the arrow buttons to select Fax functions, and then press
OK
.
3.
Use the arrow buttons to select Clear saved faxes, and then press
OK
.
4.
Press
OK
to confirm the deletion.
Use fax on a DSL, PBX, ISDN, or VoIP system
HP products are designed specifically for use with traditional analog phone services. They are not
designed to work on DSL, PBX, ISDN lines, or VoIP services, but they might work with the proper setup
and equipment.
NOTE:
HP recommends discussing DSL, PBX, ISDN, and VoIP setup options with the service
provider.
The HP LaserJet product is an analog device that is not compatible with all digital phone environments
(unless a digital-to-analog converter is used). HP does not guarantee that the product will be compatible
with digital environments or digital-to-analog converters.
DSL
A digital subscriber line (DSL) uses digital technology over standard copper telephone wires. This
product is not directly compatible with digital signals. However, if the configuration is specified during
DSL setup, the signal can be separated so that some of the bandwidth is used to transmit an analog
signal (for voice and fax) while the remaining bandwidth is used to transmit digital data.
NOTE:
Not all faxes are compatible with DSL services. HP does not guarantee that the product will
be compatible with all DSL service lines or providers.
The DSL modem requires a high-pass filter. The service provider typically provides a low-pass filter, for
normal telephone wiring.
NOTE:
Contact the DSL provider for more information or for assistance.
ENWW
Use fax 113