HP LaserJet M1522 Multifunction Printer series - Manual (Page 31)

Table 2-7 Service menu
Menu item Sub-menu item Description
Print T.30 trace Never
If error
At end of call
Now
Prints or schedules a report that is used to troubleshoot fax
transmission issues.
Cleaning mode Cleans the product when specks or other marks appear on printed
output. The cleaning process removes dust and excess toner from
the paper path.
When selected, the product prompts you to load plain Letter or A4
paper in tray 1. Press
OK to begin the cleaning process. Wait until
the process completes. Discard the page that prints.
USB speed High
Full
Sets the USB speed.
Less paper curl On
Off
When printed pages are consistently curled, this option sets the
product to a mode that reduces curl.
The default setting is Off.
Archive print On
Off
When printing pages that will be stored for a long time, this option
sets the product to a mode that reduces toner smearing and
dusting.
The default setting is Off.
Restore defaults Sets all customized settings to the factory default values.
Table 2-8 Network config menu
Menu item Sub-menu item Description
TCP/IP config Automatic
Manual
Automatic automatically configures all the TCP/IP settings via
DHCP, BootP or AutoIP.
Manual requires you to manually configure the IP address, subnet
mask, and default gateway.
The control panel prompts you to specify values for each address
section. Use the arrow buttons to increase or decrease the value.
Press
OK to accept the value and move the cursor to the next field.
As each address is completed, the product prompts for address
confirmation before moving to the next one. After all three
addresses are set, the product automatically restarts.
Link speed Automatic
10T Full
10T Half
100TX Full
100TX Half
Sets the link speed manually if needed.
After setting the link speed, the product automatically restarts.
Auto crossover On Sets the auto crossover function.
ENWW Control-panel menus 19