HP XP P9500 Storage - Manual (Page 161)

Description Item
• Pairs: The number of data volumes registered in the mirror.
•
Capacity: The total capacity of data volumes registered in the mirror
• Copy Pace: The pace for an initial copy activity for one volume.One of the following appears:
High, Medium, or Low. The default setting is Low. Copy Pace is blank if the mirror is a restore
mirror.
•
Delta Resync Failure: The processing that would take place when the delta resync operation
cannot be performed.
[ Entire]: Whole data in the P-VOL is copied to S-VOL when the delta resync operation cannot
be performed.
[ None]: No processing takes place when the delta resync operation cannot be performed.
Therefore, the S-VOL will not be updated.
•
Transfer Speed: The line speed (in megabits per second) of data transfer. One of the following
appears: 256, 100, or 10.
This setting does not take effect on master journals. However, if the RAID Manager
horctakeover command is used to change a master journal into a restore journal, this setting
takes effect on the journal.
• EXCTG, DKC/CTRLID: Mainframe only. Displays the following information sequentially if the
journal belongs to an extended consistency group:
The extended consistency group number
The serial number and the LDKC number (the LDKC number is enclosed by parentheses)
A slash (/), the controller ID
This column is blank if the journal does not belong to any extended consistency group.
•
Remote Command Device: Displays LDEV numbers if the mirror is assigned to the remote
command device. This column is blank if the mirror is not assigned to the remote command
device.
Displays detailed information about the previous journal. Previous
Displays detailed information about the next journal. Next
Closes the Journal Detail dialog box. Close
Change Journal Option dialog box
Use this dialog box to change the options that affect pairs in a journal.
See
“Changing options used by journals ” (page 81) for complete information.
Change Journal Option dialog box 161