HP XP P9500 Storage - Manual (Page 87)

6. Enter a new RIO MIH Time. This is the amount of time the system waits before a data transfer
operation is flagged as failed. The range is from 10-seconds to 100-seconds; 15-seconds is
the default.
7. Click Set when finished.
8. Review your settings in the Preview list in the Journal Operation window.
•
To modify a setting, right click and select Modify.
•
To cancel a setting, right click and select Cancel.
9. Click Apply to apply the settings. If an error occurs, right click the item in the Preview list and
select Error Detail.
Deleting logical paths
You can delete logical paths from the primary or secondary systems.
Prerequisite information
•
Before deleting logical paths, make sure that the remaining number of logical paths will be
greater than the minimum number of paths setting. The delete path operation will fail if the
number of remaining paths is equal to or less than the minimum number of paths.
•
The primary system administrator can delete logical paths between the initiator port of the
primary system and the RCU target port of the secondary system. The secondary system
administrator can delete logical paths between the initiator port of the secondary system and
the RCU target port of the primary system.
Procedure 24 To delete a logical path
1. In the Remote Web Console main window, select Actions > Remote Copy > Continuous Access
Journal > DKC Operation.
2. Click to change the mode from View to Modify.
3. In the Display box, select DKC. The tree and full list display information about remote systems.
4. Locate the desired remote system, right-click, and select Delete Path. A confirmation message
appears.
5. Click OK.
6. Review your settings in the Preview list in the Journal Operation window.
•
To modify a setting, right click and select Modify.
•
To cancel a setting, right click and select Cancel.
7. Click Apply to apply the settings. If an error occurs, right click the item in the Preview list and
select Error Detail.
Deleting the Cnt Ac-J relationship
You can remove the Continuous Access Journal pair relationship between primary and secondary
systems.
Prerequisite information
•
Removing the relationship between the primary and the secondary systems also removes the
logical paths between them.
•
This operation must be performed on both the primary and secondary P9500 systems.
Procedure 25 To delete the Continuous Access Journal relationship
1. In the Remote Web Console main window, select Actions > Remote Copy > Continuous Access
Journal > DKC Operation. The DKC Operation window displays.
2. Click to change the mode from View to Modify.
Logical path maintenance 87