HP XP P9500 Storage - Manual (Page 58)

Range Content Parameter Column
00000 to 99999 Serial number of the secondary storage system DKCSN G
N/A Mirror: All pairs in the same mirror are released. Range
2
H
Volume: Only specified pair in the mirror is released
N/A Disable: The host cannot write data in the secondary data
volume while the pair is being split. DeleteMode
3
I
Enable: The host can write data in the secondary data volume
while the pair is being split.
N/A Normal: The pair is released only when the pair status can
be changed to Simplex in the primary storage system. SuspendMode
4
J
Force: Under any condition, the pair is forcibly released in
the site on which the operation is performed.
Notes:
1. When the specified volume type (primary or secondary) in VolType is different from the actual volume type, the
spreadsheet ends normally but the pair is not released.
2. An error occurs if you specify Mirror and multiple Continuous Access Journal pairs in the same spreadsheet. The
H20000 (XP24000/XP20000 Disk Array) Group option is also available for this field. The setting is the same
whether you specify Mirror or Group. Mirror is recommended.
3. If you specify Force as the SuspendMode, specify Mirror as the Range. Even if the spreadsheet ends normally when
you specify Volume as the Range and Force as the DeleteMode, the pair is not released. If you specify Force as the
SuspendMode for the volumes other than Continuous Access Journal pairs, an error does not occur. In this case,
the pair is not released.
Troubleshooting runtime CLI errors in Continuous Access Journal Z
If a results file indicates that a spreadsheet operation did not happen correctly, one of the following
conditions might have occurred:
•
A communication error.
•
Volumes or pairs are not in “Ready” status and are not ready to accept changes.
•
Another user is working with the storage system in RWC in Modify mode.
58 Continuous Access Journal Z operations