HP XP Racks - Manual (Page 110)

If one or more of the displayed statuses are BROKEN, remove and then re-
install HDLM.
20
.
Execute the following command to make sure that the hdisk.
# cfgmgr
21
.
Execute the following command and verify that the status of the hdisks is
Available:
# lsdev -Cc disk
hdisk0 Available 1S-08-00-8,0 16 Bit LVD SCSI Disk Drive
hdisk1 Available 1S-08-00-9,0 16 Bit LVD SCSI Disk Drive
hdisk2 Available 1S-08-00-10,0 16 Bit LVD SCSI Disk Drive
hdisk3 Available 1H-08-02 Hitachi Disk Array (Fibre)
hdisk4 Available 1H-08-02 Hitachi Disk Array (Fibre)
...
Make sure that all the displayed HDLM-related devices are Available.
hdisks 0 to 2 are the physical device file names of the host's internal
disks.
hdisk 3 and the following are the logical device file names that correspond
to physical volumes in the storage system.
22
.
Activate the volume group used by HDLM.
# varyonvg volume-group-name
23
.
Mount the file system used by HDLM.
# mount file-system-mount-point
24
.
Execute the dlnkmgr command's view operation to check the status of
each program:
# /usr/DynamicLinkManager/bin/dlnkmgr view -sys
HDLM Version : x.x.x-xx
Service Pack Version :
Load Balance : on(rr)
Support Cluster :
Elog Level : 3
Elog File Size (KB) : 9900
Number Of Elog Files : 2
Trace Level : 0
Trace File Size(KB) : 1000
Number Of Trace Files : 4
Path Health Checking : on(30)
Auto Failback : on(60)
Intermittent Error Monitor : off
Dynamic I/O Path Control : off(10)
HDLM Manager Ver WakeupTime
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss
HDLM Alert Driver Ver WakeupTime ElogMem Size
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss 4000
HDLM Driver Ver WakeupTime
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss
License Type Expiration
Permanent -
KAPL01001-I The HDLM command completed normally. Operation name
= view, completion time = yyyy/mm/dd hh:mm:ss
3-44
Creating an HDLM Environment
Hitachi Dynamic Link Manager (for AIX) User Guide