HP XP Racks - Manual (Page 142)

During installation, the KAPL09241-W message might be output. In this
case, installation of HDLM continues, but installation of HDLM components
has failed. After installing HDLM, resolve the problem according to the
KAPL09241-W message if necessary.
When installation is successful, the KAPL09211-I message is output and
the host restarts. After the host has restarted, check to make sure that
the settings have been updated as specified in the installation information
settings file.
Note that, if the upgrade installation or re-installation ends in an error,
HDLM may no longer be installed at all. In this case, proceed to step 12.
If unattended installation ends normally, proceed to step 13.
13
.
If HDLM was not upgraded or re-installed properly, perform a new
installation of HDLM.
¢
When AIX 5L V5.3 is used, and the boot disk is in a multi-path
configuration
Execute the following command to shut down the host, and then
perform the new installation procedure from step 1:
# shutdown -F
¢
When an environment other than the above is used
Execute the following command to restart the host, and then perform
the new installation procedure from step 1:
# shutdown -Fr
After performing a new installation of HDLM, set up HDLM again based on
the HDLM settings backed up in step 7.
14
.
Unmount the DVD-ROM.
# umount /cdrom
15
.
Delete the created mount directory.
# rm -r /cdrom
16
.
Delete the installation information settings file.
# rm -r /directory-containing-the-installation-information-
settings-file
17
.
Perform the procedure appropriate for the installation type.
If you are performing a new installation, perform steps 15 to the end of
the procedure described in When Installing HDLM in a Boot Disk
Environment on page 3-31 of Performing a New Installation of HDLM on
page 3-26 .
If you are performing an upgrade installation or a re-installation, perform
steps 15 to the end of the procedure described in When Installing HDLM
in a Boot Disk Environment on page 3-45 of Performing an Upgrade
Installation or Re-installation of HDLM on page 3-38 .
3-76
Creating an HDLM Environment
Hitachi Dynamic Link Manager (for AIX) User Guide