HP XP Racks User Manual
Page 115
During installation, the KAPL09241-W message might be output. In this
case, installation of HDLM continues, but installation of HDLM components
has failed. After installing HDLM, resolve the problem according to the
KAPL09241-W message if necessary.
17
.
For a re-installation, execute the following command:
¢
When installing HDLM from the DVD-ROM
# /directory-in-which-the-DVD-ROM-is-mounted/installux.sh
or
# installp -aXFd /directory-in-which-the-DVD-ROM-is-mounted/
HDLM_AIX all
¢
When installing HDLM from the directory to which the DVD-ROM was
copied
# /directory-copied-from-DVD-ROM/installux.sh
or
# installp -aXFd /directory-copied-from-DVD-ROM/HDLM_AIX all
Even though a message asking you to restart the host is displayed during
installation, you do not have to restart the host.
If you execute the dlmrmdev utility without the -e parameter specified at
step 12 and then the KAPL09172-E message is displayed, the hdisk for the
device that is managed by HDLM still remains.
If you execute the dlmrmdev utility with the -e parameter specified at
step 12 and then the KAPL09172-E message is displayed, the hdisk for the
device that is managed by HDLM still remains, and its status is
Available. Re-execute the procedure in step 12.
If re-installation ends with an error, HDLM might be removed. In this
case, proceed to step 19.
During installation, the KAPL09241-W message might be output. In this
case, installation of HDLM continues, but installation of HDLM components
has failed. After installing HDLM, resolve the problem according to the
KAPL09241-W message if necessary.
18
.
Execute the following command to make sure that the package is
installed.
# lslpp -la DLManager.mpio.rte
Make sure that the fileset item in the output listing contains
DLManager.mpio.rte, and all the displayed statuses are COMMITTED.
If one or more of the displayed statuses are BROKEN, remove HDLM, and
then proceed to step 19 to perform a new installation of HDLM.
19
.
If HDLM was not upgraded or re-installed properly, perform a new
installation of HDLM.
¢
When AIX 5L V5.3 is used, and the boot disk is in a multi-path
configuration
Execute the following command to shut down the host, and then
Perform Operations for HDLM Management-
:
Creating an HDLM Environment
3-49
Hitachi Dynamic Link Manager (for AIX) User Guide