HP XP Racks - Manual (Page 174)

$ mkvdev -vdev hdisk-name -vadapter virtual-SCSI-server-
adapter-name
¢
To create a logical volume as a virtual target device
$ mkvdev -vdev logical-volume-name -vadapter virtual-SCSI-
server-adapter-name
25
.
Execute the following command in the client logical partition to
reconfigure the device:
# cfgmgr
26
.
Execute the following command in the client logical partition to check that
the physical volume has been recognized as hdisk:
# lsdev -Cc disk
Make sure that the following execution result is displayed:
hdisk1 Available Virtual SCSI Disk Drive
27
.
Execute the following command to restore the backed up volume group:
# restvg -f any-desired-file-name-or-device-name hdisk-name
Removing a NIM resource from SPOT
This subsection explains how to remove HDLM from a SPOT.
1
.
Log in to AIX as the root user.
2
.
Execute the following command.
# nim -o maint -a installp_flags=u -a
filesets=DLManager.mpio.rte name-of-NIM-SPOT-that-contains-HDLM
For details about the nim command, see the AIX documentation.
Removing Hitachi Network Objectplaza Trace Library (HNTRLib2)
When you remove HDLM, if the KAPL09019-E or KAPL09020-E message is
output, follow the directions below to remove HNTRLib2.
To remove HNTRLib2:
1
.
Log in to AIX as the root user.
2
.
Execute the following command to unregister the name of the bundled
program products.
# /opt/hitachi/HNTRLib2/etc/hntr2cancel "Hitachi Dynamic Link
Manager"
3
.
Execute the following command.
# /opt/hitachi/HNTRLib2/etc/hntr2setup
The HNTRLib2 setup menu will appear.
3-108
Creating an HDLM Environment
Hitachi Dynamic Link Manager (for AIX) User Guide