Innovate Motorsports LogWorks 3 - Manual (Page 56)

LogWorks3_Manual_1.01.doc - 56 -
6.4 Viewing existing log Files
Use the Tool in the Main Dashboard Toolbar or use the menu item:
File->Open File Log..
LogWorks can load LogWorks 1, 2 and 3 log files. LogWorks log files have the file extension .log.
It can also load files saved in the .dif Format (used with Excel) and .d32 format. The .d32 format
is used by the DL-32 device to store logs.
.log Files store a much more complete log file than either .dif or .d32 files. .log files
also store the complete Channel configuration, gauge set, Window positions, charts and
so on used when manipulating the log.
After a log is loaded, LogWorks opens a Log Window for that log.
Channel configurations in use during recording or downloading the log file are also part of that file
and are applied to the visible channels.
You can change those configurations at any time, but the changes will only affect the log in that
file.
6.5 Downloading from an LM-1 or LM-2/DL-32 recorded SD
card
When logged data is downloaded from an LM-1 or from an SD card that was recorded on by an
innovate device, like the LM-2 or DL-32, the following rules for channel descriptions apply:
Data from a LM-1:
6.5.1 Downloading LM-1 data
To download logged data from an LM-1 use:
File->Import/Download->Download LM-1 log…
Or use the Tool in the Main Dashboard Toolbar.
This creates a new LM-1 log by downloading data internally logged in the LM-1. During
downloading the car may not be running (engine off) because the WB sensor’s heater is switched
off during downloads. After a download completes, the LM-1 is automatically restarted (heater
runs again).
Channels configured from the Main Dashboard that are marked as coming from an LM-1 are
applied. If no channels ever were configured, like after LogWorks is used the first time, the
channel configuration wizard will ask you to configure the channels.