JKS 2210 - Manual (Page 2)

JKS2210 JKS Adjustable Coil Spacer Installation 2 Page
Description QTY
A Threaded Tube 2
B Adjuster Ring 2
C Isolator Pad 2
D 5/16” x 1-1/4” Cap Bolt 2
E Bump Stop Adapter 2
F Bump Stop Plug 2
G Polyurethane Bump Stop 2
H 10mm x 55mm Cap Bolt 2
I 3/8” Flat Washer 2
J 10mm Locking Nut 2
Installation
‰ 1. REMOVE FRONT COIL SPRINGS
 Remove the front coil springs per the factory ser-
vice manual instructions for your vehicle.
HINT: A coil spring compressor is useful for re-
moval.
Depending on the application, it may be neces-
sary to completely or partially remove any of the
following components before spring can be free
from upper mount.
 Shock Absorber
 Swaybar
 Brake Line
 ABS Wire
‰ 2. PREPARE SPRING RETAINER
The factory bump stop holder is welded to the upper spring
retainer and must be permanently removed in order to
install the ACOS™.
 Pry the rubber bump stop (jounce bumper) free
from the bump stop holder.
 Remove the rubber isolator pad from the upper
coil spring retainer.
 Locate the factory weld that secures the bump
stop holder to the upper coil spring retainer.
 Cut away the bump stop holder immediately above
the weld as illustrated. HINT: A die grinder with
cut-off wheel or reciprocating saw is useful for cut-
ting away the bump stop holder.
 Remove any sharp edges from the cut portion of
the upper spring retainer. HINT: A file or deburring
tool is useful for removing sharp edges.