MagTek EC2000 99875607 - Manual (Page 111)

4 - Removal and Re-installation
ExpressCard 2000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 111
4.14 How to Remove / Re-install the Exit Transport Module
Approximate time to remove: 5 minutes plus any sub-procedures
Approximate time to re-install: 5 minutes plus any sub-procedures
The exit transport module takes cards from the XY transport module after embossing, and moves them
either to the card rejection bin or to the tipper and exit ramp. It includes an integrated MagnePrint reader,
which can optionally be used to read each issued card’s magnetic stripe and produce a digital identifier
(or DI) for later validation that the card is genuine and that its encoded data has not been altered. The exit
transport is attached to the center of the device’s top deck plate.
Figure 4-90 - Exit Transport Module (FRONT LEFT VIEW)
To remove the exit transport module, follow these steps:
1) Prepare the device for replacing parts by following the steps in section 4.1 How to Prepare the
Device for Removing / Re-installing Modules. At the end, the device should be powered down with
all external cables safely disconnected.
2) Remove the tipper and exit ramp module. For detailed steps, see section 4.13 How to Remove / Re-
install the Tipper and Exit Ramp Module.
3) Locate the multi-connector panel in the top deck plate, to the left of the exit transport.