MagTek EC2000 99875607 - Manual (Page 126)

4 - Removal and Re-installation
ExpressCard 2000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 126
4) On the right side of the device, pull the embedded PC out a few inches by following the first few
steps in section 4.15 How to Remove / Re-install the Embedded PC.
5) Disconnect the plug that connects the embedded PC’s COM2 port to the power controller, as shown
in Figure 4-108.
Figure 4-108 - Embedded PC Communication Input from Power Controller (RIGHT VIEW)
6) Disconnect the plug that connects the embedded PC’s power input to the power controller, as shown
in Figure 4-109.
Figure 4-109 - Embedded PC Power Input from Power Controller (RIGHT VIEW)
7) Use the 5/64” Allen wrench to remove the five screws that secure the hopper deck plate to the hopper
module, and carefully move the hopper deck plate out of the way to access the right connector panel
underneath it (see Figure 4-110).