MagTek EC2000 99875607 - Manual (Page 89)

4 - Removal and Re-installation
ExpressCard 2000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 89
Figure 4-66 - XY Transport Ground Cable (TOP VIEW FROM REAR)
5) Use the No. 2 Philips screwdriver to remove the screw, and set it aside.
6) Snap open the XY transport ribbon cable clamp between the rails as shown in Figure 4-67.
Figure 4-67 - XY Transport Ribbon Cable (TOP VIEW FROM FRONT)
7) Grasping the XY transport ribbon cable by the connector, not the cable itself, disconnect it from the
top deck.
8) Locate the connectors in the middle of the Y stepper connection cable, which runs along the left rail
of the XY transport (see Figure 4-68).
9) Hold the two connectors (not the wires), and disconnect them.