MagTek EC2000 99875607 - Manual (Page 70)

4 - Removal and Re-installation
ExpressCard 2000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 70
11) Loop a cable tie through the anchor point on the top deck plate near the front of the device, tie the
EXC HOME SENS cable to the other cables, and tighten and trim the cable tie (see Figure 4-41).
Figure 4-41 - EXC HOME SENS Cable Routing (TOP LEFT VIEW)
12) Continue routing the EXC HOME SENS cable along the right side of the device and thread it under
the right side of the HOPPER SHUTTLE board, then out the front as shown in Figure 4-42.
Figure 4-42 - Routing the EXC HOME SENSOR Cable (FRONT VIEW)
13) Use a miniature cable tie to fasten the EXC HOME SENS cable near the front of the device, securing
it to the bundle of cables that runs along the right side of the device (see Figure 4-43).