MagTek EC2000 99875607 - Manual (Page 33)

3 - Preventive Maintenance
ExpressCard 2000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 33
3.6 Service the Hopper Module
Follow these steps to service the hopper transport:
1) Use the MCP Commands page (see section 2.9 How to Use Maintenance Functions On the
Touchscreen) to move the hopper transport from the front to the rear of the device to verify the
movement is smooth and there is no belt slippage.
2) Only if the hopper transport rods are dirty, wipe off the dirt with a soft, lint-free cloth.
3) Check the hopper transport drive belt for signs of damage. If it is damaged, contact MagTek Support
Services for a replacement.