MagTek EC2000 99875607 - Manual (Page 71)

4 - Removal and Re-installation
ExpressCard 2000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 71
Figure 4-43 - Securing the EXC HOME SENS Cable (TOP VIEW FROM FRONT)
14) Use a miniature cable tie to fasten the EXC HOME SENS cable to the same bundle of cables, near the
flex cable as shown.
15) Locate the HOME SENS cable that comes from the rear of the hopper module. Route it along the
rear wall of the device to the left side of the hopper module, and below the shielding around the
image printer as shown in Figure 4-44. If there is not enough slack in the cable, use the 5/32” Allen
wrench to seat the cable below the axle of the hopper motor’s gear as shown in Figure 4-45.