MagTek EC2000 99875607 - Manual (Page 66)

4 - Removal and Re-installation
ExpressCard 2000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 66
Figure 4-35 - Disconnecting the Hopper Transport Flex Cable
12) Use the 5/32 in. ball end Allen wrench to remove the four screws that secure the four corners of the
hopper module to the top deck plate. Some screws require inserting the Allen wrench through
openings in the hopper deck plate. See Figure 4-30 and Figure 4-36 for reference.
Figure 4-36 –3 of 4 Hopper Module Screws (TOP RIGHT VIEW)
13) Locate the hopper transport belt. It will remain attached to the hopper transport during removal.
14) Release the tension on the hopper transport belt by using the 5/32” Allen wrench to loosen the belt
tension screw on the front of the hopper module (see Figure 4-37).