MagTek EC2000 99875607 - Manual (Page 130)

4 - Removal and Re-installation
ExpressCard 2000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 130
To re-install the power controller and backplane, reverse the steps you followed to remove it. Follow
these hints to make the re-installation easier:

Before inserting the tray, re-route the two cables that come off the right end of the tray as shown in
Figure 4-114, then pull them through the right access door as shown in Figure 4-115.

Before pushing inserting the tray all the way into the left access door, move the two cables you lifted
during installation, and route them across the left edge with the other cables as in Figure 4-116.
Figure 4-114 - Cable Routing for Inserting Power Controller (LEFT VIEW)
Figure 4-115 - Pulling Power Controller Cables to Right Access Door (RIGHT VIEW)
Figure 4-116 - Routing Power Supply Cables Before Final Insertion (LEFT VIEW)