MagTek EC2000 99875607 - Manual (Page 74)

4 - Removal and Re-installation
ExpressCard 2000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 74
Figure 4-48 - Sensor Cables Plugged In To HOPPER SHUTTLE Circuit Board (FRONT VIEW)
19) Plug the two sensor cables at the rear of the device into the two plugs on the circuit board at the top
rear right of the hopper module. The cable labeled “…to J2…” goes to the REAR plug, and the cable
labeled “…to J1…” goes to the FRONT plug. See Figure 4-49.
Figure 4-49 - Sensor Cables at Rear of Hopper Module (RIGHT VIEW)
20) Loop the hopper transport drive belt around the gear of the hopper drive motor at the rear of the
device as shown in Figure 4-50.