MagTek EC2000 99875607 - Manual (Page 114)

4 - Removal and Re-installation
ExpressCard 2000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 114
Figure 4-93 - Embedded PC Thumb Screws (RIGHT VIEW)
5) Use the finger holes to slowly and carefully pull the embedded PC out just far enough to make the
connectors along its edge accessible (see Figure 4-94). While pulling, use a flashlight and other tools
as appropriate to make sure its cables do not snag inside the device.
Figure 4-94 – Connectors On Right Edge of the Embedded PC (TOP VIEW FROM RIGHT)
6) Disconnect all the cables connected along the right edge of the embedded PC, plus the power
connector near the front edge. The connectors are shown in Figure 4-95.