AT&T DEFINITY Remote Port Security Device - Manual (Page 53)

RPSD System Administrator Command Set
This section describes the commands available on the RPSD Lock and their syntax. The
procedures in which the commands are used have been described earlier in this chapter.
This material is provided as a quick reference.
Also described in this section is the method of accessing the help screens that accompany the
Menu of Commands.
The Menu of Commands available to the system administrator is as follows:
- Menu of Commands ---
A - Add User
B - Block User
U - Unblock User
T - Test User
R - Remove User
L - List User Table
CR - Change Restriction
LR - List Restrictions
UR - User Restrictions
LH - Log History
AH - Access History
FH - Failure History
ST - Status Display
LS - List Statistics
RS - Reset Statistics
FC - Force Connect
FD - Force Disconnect
-- For Help Type ‘?’ Followed By Command --
D - Date Set
C - Clock Set
I - ID Set
SC - Set Comms. Params
>
Note: The Menu of Commands is available at any time by pressing [ RETURN ] on the RPSD
administration terminal. The commands are not case sensitive.
A - Add User
Syntax:
a <user_id>,[secret_key] [ RETURN ]
Adds an RPSD Key user to the list of users on the RPSD Lock. The total number of RPSD Key
users at any one time is limited to twenty-five. Of the twenty-five users, ten are permanent users
and cannot be removed.
The [secret_key] can be specified by the system administrator or randomly assigned by the
Lock. If this field is omitted, it is randomly generated by the Lock.
RPSD System Administrator Command Set 3-7