AT&T DEFINITY Remote Port Security Device - Manual (Page 84)

S - Status Display
Syntax:
s [ RETURN ]
The Status Display command displays the current status of the RPSD Key to the user’s terminal.
To use this command, enter s [ RETURN ] at the > prompt.
Sample Command and Response:
>s
AT&T RPSD/KEY11 - V1.0 Firmware V2.0x Init Code:
Current Date: Mon 08/14/90 Time: 14:28:09 Log ID: 12345678
Comms Set to: 9600/8N
Current Status: Idle
The fields of the Status Display screen are:
AT&T Gives the version number of the equipment and the Key user ID.
RPSD/KEY11
Firmware Gives the version number of the firmware.
Init Code Tells where and when the device was initialized.
Current Date Gives the current date. If the date is wrong, it can be corrected using the
Date Set command described in this section.
Time Gives the current time. If the time is wrong, it can be corrected using the
Time Set command described in this section.
Log ID Provides the Log ID of the RPSD Key. To set a Log ID, use the Set Log ID
command described in this section.
Comms Set to Displays the setting of the communications parameters. To change the
communications parameters, use the Set Communications Parameters
command described in this section. The default setting is 9600 baud at
8 bits, no parity.
Current Status Provides the current status of the Key.
RPSD Key User Command Set 4-9