AT&T DEFINITY Remote Port Security Device - Manual (Page 56)

T - Test User
Syntax:
t <user_id> [ RETURN ]
Returns a seven-digit, pseudo-random code to be matched by a code from the specified RPSD
Key user. This is used to check whether the RPSD Key has been seeded properly with the secret
information. The Test Response on the RPSD Key is obtained by using the List User Information
command on the RPSD Key user’s terminal. See Chapter 4, RPSD Key Use for details on the
Key user command.
In the syntax line above, t is the command and <user_id> is the user ID. To check the user IDs,
use the List User Table command. See List User Table in this section.
Sample Command and Response:
> t KEY20
Test Response is: 8119704
>
R - Remove User
Syntax:
r <user_id> [ RETURN ]
Removes a user from the user table. This prevents that user from accessing the RPSD Lock or
the attendant RMATS channel. The ten permanent AT&T users cannot be removed. If the user
is added again, the user must reinitialize the RPSD Key with new secret information. The user
could also be re-entered if the secret key information was retained. In such a case, the Key
would not need to be reinitialized. See Chapter 2, Initializing an RPSD Key for the procedure.
In the syntax line above, r is the command and <user_id> is the user ID. When a Remove User
command is issued, the RPSD Lock requests a y or an n as confirmation of the removal. To
check the user IDs or whether a user is permanent, use the List User Table command.
See List User Table in this section.
Sample Command and Response:
> r KEY20
Are You Sure (Y/N) ? y
JPLock01 447 08/14/90 14:20:43 KEY20 -- User Removed OK --
>
3-10 RPSD System Administration