AT&T DEFINITY Remote Port Security Device - Manual (Page 92)

TABLE 5-1 (Continued)
Access Failure Messages
Code
No. Message Meaning
4 Blocked User
5 Invalid
Response
6 Outgoing Call
7 Ring - No
Answer
8 Force
Disconnect
The
administrator
placed a block
on the caller’s
RSPD Key user
ID.
The RSPD Key
responded to
the RSPD
Lock’s
challenge, but
the response
was incorrect.
An outgoing
call is being
placed. If a call
is connected,
the Lock forces
a disconnect in
order to make
the outgoing
call.
The RSPD
Lock rang the
modem, but the
modem did not
pick up.
A Force
Disconnect
command was
issued to the
RSPD Lock.
Action
No action necessary. This is a deliberate
Block command issued by the administrator.
Check the Test Responses to make sure the
RSPD Lock and RSPD Key Test Responses
match (see Chapters 3 and 4 for checking
Test Responses). If access for this Key is
desired, and the Test Responses do not
match, you will need to use the Wipe Out
command (see Chapter 4, RSPD Key Use) to
return the Key to a virgin state. Then follow
the directions for initializing the RSPD Key,
also found in Chapter 4.
No action necessary.
This is not a call failure.
Run the Modem Ring Test described in this
chapter and follow the directions for
determining the cause of failure.
No action necessary. This is a
deliberate disconnect command
issued by the administrator.
Access Failure Messages 5-5