AT&T DEFINITY Remote Port Security Device - Manual (Page 83)

I - Set Log ID
Syntax:
i <log_id> [ RETURN ]
The Set Log ID command is used to identify which Key is associated with which status message.
This is especially important where multiple devices share a single administration terminal. The
command adds the ID to the beginning of each message generated by the Key.
In the syntax described above, i is the command and log_id is an identifier of up to 8 characters
selected by you.
Sample Command and Response:
> i KEY11
KEY11 08/14/90 14:20:08 Log ID Changed OK
4-8 RPSD Key Use