AT&T DEFINITY Remote Port Security Device - Manual (Page 68)

ST - Status Display
Syntax:
st [ RETURN ]
The Status Display command displays the version, date, time, communications parameters, and
current status of the RPSD Lock.
Sample Command and Response:
> st
AT&T RPSD/JPLock01 - V1.1a Firmware V2.Ot Init. Code: DR
Current Date: Mon 11/12/90 Time: 16:11:55 Log ID:
Comms. Set to: 9600/8N
Current Status: Idle/Locked
The fields of the Status Display screen are:
AT&T
RPSD/JPLock01
Firmware
Init Code
Current Date
T i m e
Log ID
Comms Set to
Current Status
Gives the version number of the equipment.
Gives the version number of the firmware.
Tells where and when the device was initialized.
Gives the current date. If the date is wrong, it can be corrected using the
Date Set command described in this section.
Gives the current time. If the time is wrong, it can be corrected using the
Time Set command described in this section.
Provides the Log ID of the RPSD Lock. To set a Log ID, use the
Set Log ID command described in this section.
Displays the setting of the communications parameters. To change the
communications parameters, use the Set Communications Parameters
command described in this section. The default setting is 9600 baud at
8 bits, no parity.
Provides the current status of the Lock.
3-22 RPSD System Administration