Sony DCR-IP55 - Manual (Page 105)

105
“
Memory Stick
”
Operations
Using a “Memory Stick” – Introduction
Ejecting a “Memory Stick”
Confirm that the “Memory Stick” access lamp is not lit, then press the “Memory Stick”
once lightly.
While the “Memory Stick” access lamp is lit or flashing
Do not shake or strike your camcorder because your camcorder is reading the data from
the “Memory Stick” or recording the data on the “Memory Stick”. Do not turn the
power off , eject a “Memory Stick” or remove the battery pack. Otherwise, image data
breakdown may occur.
If MEMORYSTICK ERROR is displayed
Reinsert a “Memory Stick” a few times. The “Memory Stick” may be damaged if the
indicator is still displayed. If this occurs, use another “Memory Stick.”
Using a touch panel
Operation buttons for most functions using a “Memory Stick” are displayed on the LCD
screen. Press the LCD panel directly with your finger or the supplied stylus (DCR-IP55
only) to operate each function.
(1) Set the POWER switch to MEMORY/NETWORK (DCR-IP55 only).
(2) Slide OPEN in the direction of the B mark indicated on the camcorder to open the
LCD panel. The operation buttons appear on the LCD screen. You can switch the
memory playback/memory camera mode by pressing PLAY/CAM.
(3) Press FN. The operation buttons of PAGE1 appear on the LCD screen.
(4) Press PAGE2 to go to PAGE2. The operation buttons of PAGE2 appear on the LCD
screen.
(5) Press PAGE3 to go to PAGE3. The operation buttons of PAGE3 appear on the LCD
screen.
(6) Press a desired operation item.
See relevant pages for each function.