Introduction – basic operations, How to turn on the power and select the mode – Sony DCR-IP55 User Manual
Page 8
8
Introduction – Basic operations
This section describes the basic operations to operate the camcorder.
How to turn on the power and select the mode
To supply power for the camcorder, see “Step 1 Preparing the power supply” on page
17.
(1) Slide the POWER switch down while pressing the small green button, then release
your finger.
The camcorder is turned on, and then the camcorder turns to the CAMERA mode
so that the CAMERA lamp lights up.
(2) Slide the POWER switch down. Each time you slide it down, the mode changes as
follows and corresponding mode lamp also lights up.
CAMERA Use this mode when you record on a tape.
MEMORY/NETWORK (DCR-IP55)
MEMORY:
Use this mode when you record on a “Memory Stick,” or
play back or edit an image in a “Memory Stick.”
NETWORK:
Use this mode when you use the network
(DCR-IP55 only)
function. For details, refer to the supplied network function
operating instructions.
VCR Use this mode when you play back or edit an image recorded on a tape or
“Memory Stick”.
1,2
MEMORY/
NET-
WORK
CAMERA
(CHG)
POWER
OFF
ON
MODE
VCR